| 1.
Opening Case: |
First,
you do not need to remove the right side panel at all. You only need to
remove the left side panel to install all necessary components. The left
side panel provides complete access to the case. Pinch(depress) two tabs
in the back of a case with relatively strong force and slowly slide the
side panel back then up to complete its removal. Do all these carefully
to avoid any damages to the clips of the side panel. |
| 2.
Motherboard Installation |
Any
ATX motherboard lines up with the 6 permanently mounted standoffs in the
case. Simply screw the motherboard down to these standoffs to complete
the installation. |
| 3.
CD-ROM, CDR, DVD, Zip Drive, Floppy Installation |
All
screws are installed from the left side of the case only. Do not screw
the right side. You don't need to screw the right side of the bay
because the metal pieces on the right side of each bay apply pressure
and push the drives towards the left side. |
| 4.
Hard Disk Installation |
The
two internal 3.5" bays located in the bottom are on a single
removable cage. Remove this cage and put the hard disk into this cage
and re-attach it to the case with screws. Screw both left and right side
of the hard disk. |
|
|
|